Download Autodata 1989 90 carburettor maunual. by Autodata PDF

By Autodata

Show description

Read or Download Autodata 1989 90 carburettor maunual. PDF

Similar algorithms and data structures books

Reliable Data Structures in C

Trustworthy information buildings in C.

High Performance Discovery in Time Series: Techniques and Case Studies

Time-series data—data arriving in time order, or an information stream—can be present in fields reminiscent of physics, finance, track, networking, and scientific instrumentation. Designing quick, scalable algorithms for studying unmarried or a number of time sequence can result in clinical discoveries, clinical diagnoses, and maybe gains.

Additional resources for Autodata 1989 90 carburettor maunual.

Sample text

Air cleaner removed. • Crankcase breather connected. • Selector lever in position 'P' on auto trans. models. • All electrical components switched off. T 1978-80 HIF6 FZX 1271, 1318 • Test instruments (rev-counter and exhaust gas analyser) connected in accordance with manufacturer's instructions. 2 Idle Speed & CO Level Specification: Idle Speed 1,3/1,7 Manual: Automatic: 2,0: CO Level: 750 rpm 850 rpm 650 rpm 2,5± 1,0 % CO a) With choke control cable pushed fully home, check that a small clearance exists between fast-idle adjustment screw and cam (Fig.

All electrical components switched off. • Test instruments (rev-counter and exhaust gas analyser) connected in accordance with manufactu rer's instructions. Fig. 1 Idle mixture screw 42 a) Remove suction chamber. b) Check that needle guide is flush with piston face and is secure. c) Turn mixture adjuster screw (A, Fig. 1) to bring jet flush with bridge. Then turn adjuster two turns clockwise. d) Check operation of throttle and that there is 1 mm free travel. e) Refit suction chamber without damper.

Special Note: Adjustment screw will be inaccessible when fast idle cam is in high position. For this reason, briefly operate throttle valve and turn adjustment screw by 'feel'. Fig. 6 Choke valve gap-checking Fig. 8 Thro ttle valve (1/) basic setting h) Refit automatic choke cover, aligning mark on cover with mark on choke housing. and stop on carburettor body. b) Disconnect vacuum unit pull rod from throttle linkage lever (B, Fig. 4). c) Press throttle lever lightly towards closed position to take up play in linkage.

Download PDF sample

Rated 4.13 of 5 – based on 12 votes